How To Install a Pypes High Clearance Catback Exhaust on your 2007-2016 Jeep Wrangler JK

Remove the Stock tailpipe by loosening the nut attached to the midpipe using the 5/8” socket wrench. 

Once the nut is loosened with 5/8” socket, spray WD-40 on the rubber hangers on the left and the right side holding the tailpipe and muffler. (see picture of hanger) 

Using the crowbar pry the rubber hanger away from the muffler to free the muffler. Start with the passenger rear side. 

Once both hangers are removed and the muffler and is hanging, pull the muffler away from the mid pipe. 

Next step is to remove the mid pipe and the resonator.

Using the 5/8” socket loosen all the bolts to the mid pipe and the resonator.

Using WD-40 or preferred lubricant, spray all rubber hangers and pry them off with the crowbar. 

Pull the resonator away from the mid pipe and take out the mid pipe and the resonator.

Now that everything is removed start by putting the pypes midipe on with the connectors provided and tighten with 5/8” socket. 

Next connect the muffler to the mid pipe using the appropriate connectors and tighten with 5/8” socket. 

Put the tailpipe in and hang them with the hangers provided. 

Once the tailpipe is hung connect the tailpipe to the muffler but do not tighten the connector until the exhaust is aligned like wanted. 

Once aligned, tighten muffler and tailpipe connections with 5/8” socket and go listen to the new sound! 

Installation Instructions Written by ExtremeTerrain Customer Evan Crook 2/29/16 ​